Step 1-Insert The Sim Card; Step 2-Connect The Antennas - Sierra Wireless AirLink LS300 Hardware User's Manual

AirLink LS300 Hardware User Guide
18
Step 1—Insert the SIM Card
If your AirLink device requires a SIM card and it has not been installed by the
reseller, insert a SIM card into the device before connecting any external
equipment or power to the device.
To install the SIM card:
1. Remove the SIM card cover.
2. Orient the SIM card, as shown in
down. Gently slide the SIM card into the slot in the slot until it stops.
Note the direction of notched corner for proper SIM card alignment
Figure 3-1: Installing the SIM card
3. Replace the SIM card cover.
Step 2—Connect the Antennas
The LS300 has 2 antenna ports. Both are SMA female bulkhead connectors.
• Main antenna port: This is the primary transmit and receive port for the
radio.
• Rx Diversity/GPS antenna port: This is a dual function receive/diversity
port and GPS receive port. When used for GPS, a bias supply may be
enabled in the ALEOS software for use with active antennas.
Note: The diversity/GPS port is receive only, it does not transmit.
Figure 3-1 with the gold contacts facing
4112895