Displaying Atm Port Information - Cabletron Systems SMARTSWITCH ROUTER 9032578-05 User's Reference Manual

Displaying ATM Port Information

Displaying ATM Port Information
There are a variety of ATM statistics that can be accessed through the command line
interface. The atm show commands can only be used in Enable mode.
To display information about the VPL configurations on an ATM port:
Displays the VPL configurations
on an ATM port.
The following is an example of the information that is displayed with the command listed
above:
ssr(atm-show)# vpl port at.9.1
VPL Table Contents for Slot 9, Port 1:
Virtual Path Identifier: 1
Administrative Status:
Operational Status:
Last State Change:
Service Definition:
The following is a description of the display fields:
• Virtual Path Identifier
• Administrative Status
• Operational Status
• Last State Change
• Service Definition
48
Service Class:
Peak Bit Rate:
Sustained Bit Rate: 0 Kbits/sec (0 cps)
Maximum Burst Size: 0 cells
Encapsulation Type: Routed LLC
F5-OAM:
atm show vpl port <port list> | all-ports
Up
Up
1581
ubr-default
UBR
Best Effort
Requests & Responses
Identifies a particular VP.
Shows whether the VP is a viable network
element.
Up indicates a viable network element.
Down indicates a non-viable network element.
Shows whether the VP is passing traffic.
Up indicates traffic.
Down indicates no traffic.
Shows the last time the VP went up or down.
Time is in seconds relative to system bootup.
Shows the name of the defined service and its
traffic parameters
SmartSwitch Router User Reference Manual