Displaying Rmon Information - Cabletron Systems SMARTSWITCH ROUTER 9032578-05 User's Reference Manual

Chapter 23: RMON Configuration Guide
• Samples taken at 300 second (5 minute) intervals.
• A "Startup" alarm generation condition instructing the SSR to generate an alarm if the
sample is greater than or equal to the rising threshold or less than or equal to the falling
threshold.
• Compare value at time of sampling (absolute value) to the specified thresholds.
• Rising and falling threshold values are 1.
• Rising and falling event index values are 15, which will trigger the previously-
configured Event.
ssr#(config) rmon alarm index 20 variable 1.3.6.1.2.1.31.1.5.0 interval
300 startup both type absolute-value rising-threshold 1 falling-
threshold 1 rising-event-index 15 falling-event-index 15 owner "help
desk"

Displaying RMON Information

The CLI rmon show commands allow you to display the same RMON statistics that can
be viewed from a management station. To display RMON statistics for the SSR, use the
following CLI command lines in Enable mode:
1
To show Ethernet statistics.
To show all events and logs.
To show all alarms.
To show histories and logs.
To show hosts and logs.
To show all Host Top N and
logs.
To show matrices and logs.
To show all channels.
To show all filters.
To show all packet captures
and logs.
To display the RMON 2
Protocol Directory.
To display the RMON 2
Protocol Distribution.
322
rmon show etherstats <port-list>|all-ports
rmon show events
rmon show alarms
rmon show history <port-list>|all-ports
rmon show hosts <port-list>|all-ports [summary]
rmon show host-top-n
rmon show matrix <port-list>|all-ports
rmon show channels
rmon show filters
rmon show packet-capture
rmon show protocol-directory
rmon show protocol-distribution <port-list>|all-
ports
SmartSwitch Router User Reference Manual