Valet Mode - Directed SMARTSTART ASRA-2510 User Manual

Note 1: Pressing on the brake pedal after the allocated period will shut the
down.
Note 2: The engine will continue running until the user re-enters the vehicle or
until the expiration of the engine run time.
Note 3: If the pre-programmed run-time expires or if the user shuts down the
engine remotely, the vehicle will enter Ready Mode.
Caution! Do not leave children or pets unattended in a vehicle standing in Idle
Mode.

Valet Mode

When the vehicle is in Valet Mode, the remote starter and alarm functionalities
are disabled. If the vehicle needs to be serviced, or if you park it indoors, the
Valet Mode will prevent the engine from being remote-started accidentally.
Any of the following features will put your remote car starter into Valet
Mode:

Ignition Valet: This feature allows you to put your system into Valet
Mode by using the ignition key.

Remote valet: This feature allows you to put your system into Valet
Mode by using the transmitter.
To put the system into Valet Mode
To put the system into Valet mode using the KEY (Ignition Valet Mode):
1. Insert the ignition key into the ignition switch. Within 10 sec., turn the
key 5 times successively into the IGNITION/RUN and OFF positions.
2. The parking lights will flash three times.
3. Turn the ignition OFF.
4. The LED on the antenna will come ON solid to indicate that the vehicle
has successfully entered Valet mode.
P.14
engine
User Guide