Enabling/Disabling Valet Mode - Directed 2102T Owner's Manual

Manual unlocking
Press and hold the
ing lights will flash twice to confirm the doors have been unlocked.
Manual locking
Press and release the
red indicating that the command is being sent, and the parking lights will flash
once to confirm the doors have been locked.
Note: When installed with certain remote starter models, the doors might not
locks when the vehicle is running by the key.

Enabling/Disabling valet mode

Valet mode can be enabled and disabled using the following procedure.
When the feature is enabled, the automatic locking/unlocking operation upon
entering the active zone will be disabled. However, manual locking/unlocking
of the vehicle is possible in valet mode, as long as the ignition is off.
Enable valet mode
Within the active zone, quickly press and release the key fob
then press and hold until the remote LED flashes red to confirm the system has
entered valet mode. The key fob LED will no longer flash to indicate whether
you are in the active zone or not.
Disable valet mode
Within the active zone, quickly press and release the key fob
then press and hold until the remote LED flashes red to confirm the system has
exited valet mode. The key fob LED will flash to indicate whether you are in the
active zone or not.
8
button until the LED on the remote flashes red. The park-
button for 1 second. The LED on the remote will flash
© 2012 Directed. All rights reserved.
button twice,
button twice,