Remote-Starting Your Vehicle; Setting Your Vehicle Into Ready Mode - Directed SMARTSTART ASRA-2510 User Manual

Remote-Starting Your Vehicle

Setting Your Vehicle into Ready Mode

If your vehicle has a manual transmission you must read the following
indications. The unit must first be set to Ready Mode in order to start the vehicle
by remote. If the unit is not set to Ready Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake,
depending on the option that was selected by your installer. Therefore, you must
follow the appropriate procedure between the two described below in order to set
your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and
stopped at any time. The system will exit Ready Mode if a door, the hood or the
trunk is opened, if the brake pedal is pressed, if the parking brake is disengaged
IGNITION ON (RUN)
or if the ignition key is turned to the position.
User guide P.9