Directed SMARTSTART ASRA-2510 User Manual page 13

Activating Idle mode (Automatic Transmission):
1. With the engine running, make sure to release the brake pedal and
press the
until the parking lights come ON.
Note: SmartStart™ can be setup to use the
Idle mode, Turbo mode or Ready mode.
2. Remove the ignition key from the ignition switch.
The engine will continue running.
3. Exit the vehicle. All doors, the hood and trunk should be closed
4. Press the
arm the alarm. The engine will be kept running at idle speed.
a. When re-entering the vehicle, the user must reinsert the key into
the ignition and turn it to the ON position (not Crank) without
pressing on the brake.
b. Once the key is in the ON position, press on the brake pedal to put
the transmission in gear.
c. Drive off.
If your vehicle has a manual transmission, Idle mode can be activated through
the same routine as that used for Ready mode (page 9); at the last step, the
button is pressed instead of the other buttons. This will lock the
doors, arm the system and leave the engine running.
NEW FEATURE – Push-To-Start Idle Mode
This feature is a variation of Idle mode, but made specifically for Push-To-Start
vehicles, with automatic or manual transmissions. (Consult your installer for
availability of this feature.) Follow the same steps as the normal Idle Mode
procedure, except for when re-entering the vehicle while the engine is running;
1. Close all doors.
2. You have 1.5 minutes (or 3 minutes) to press on the brake pedal, to get
in gear and drive off.
User guide
, or
button to lock the doors, to arm the starter kill and to
button on the transmitter
icon to activate
P.13