Directed AS-RFK2300 User Manual
Directed AS-RFK2300 User Manual

Directed AS-RFK2300 User Manual

Two-way fm led remote system

Advertisement

Quick Links

Two-Way FM LED Remote System
AS-RFK2300
User Guide
Available functionalities depend on vehicle. Consult your dealer for more information.
Designed & engineered in Canada
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (EIRP) is not more than that required for successful communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
Doc#: 120713
Rev:1.6
© 2012
- AS-RFK2300 -
- CP -
Canada

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AS-RFK2300 and is the answer not in the manual?

Questions and answers

Summary of Contents for Directed AS-RFK2300

  • Page 1 NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment. Doc#: 120713 Rev:1.6 © 2012 - AS-RFK2300 - - CP - Canada...
  • Page 2: Table Of Contents

    Note: Some functionalities and behaviours may not be available on certain vehicles. See dealer for available options. Table of Contents Government Regulations ......................3 Using the Remote Control ...................... 4 Vehicle Presets (only with remote starter) ................4 Heater ..........................4 Windshield Wipers, Radio &...
  • Page 3: Government Regulations

    Government Regulations This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
  • Page 4: Using The Remote Control

    Using the Remote Control Your remote system is equipped with a 5-button multi-channel remote control. The functions of the transmitter are as follows: LOCK (LED 1): Locks the UNLOCK (LED 2): doors. Unlocks the doors. TRUNK (LED 3): Opens START (LED 4): Remote the TRUNK.
  • Page 5: Remote-Starting Your Vehicle (Only With Remote Starter)

    Remote-Starting your Vehicle (only with remote starter) Remote-Starting Press the button for approximately 1 second. The remote will beep once to inform you that the vehicle has received your signal. Approximately 5 seconds later, the engine will start. The remote will confirm the remote starter’s activation by beeping 3 times.
  • Page 6: Panic Mode

    Proceed as follows to set the system to Idle Mode: With the engine running, make sure to release the brake pedal and press the button on the transmitter until the parking lights come ON. Remove the ignition key from the ignition switch. The engine will continue running.
  • Page 7: Status Request When The Engine Is Running

    Status Request When the Engine is Running When the vehicle doors are locked: LED # 1 will flash 3 times to denote that the vehicle’s doors are locked. When the vehicle doors are unlocked: LED # 2 will flash 3 times to denote that the vehicle’s doors are unlocked. RUN TIME Beep(s) LED #1...
  • Page 8: Abridged Command Table

    Abridged Command Table Note: Some functionalities and behaviours may not be available on certain vehicles. See dealer for available options. Command Sequence  Lock  Unlock  Trunk  Start  Stop  AUX 1 then  AUX 2 then Hold ...

Table of Contents