Extended Run Time; Disable/Enable Led Flashing - Directed SMARTSTART ASRA-2510 User Manual


Turn the ignition key to the IGNITION ON (RUN) position.

Press and hold the
2 seconds, pause, and then flash once.
If Safe Start is enabled, you can activate Cold Weather Mode by:

Pressing and releasing the
the
To verify whether the system is in Cold Weather Mode (automatic transmissions
only):

Press the brake pedal:

If the vehicle is in cold weather mode, the parking lights will remain ON
while the brake pedal is pressed.

Extended Run Time

With the vehicle running under a remote start, pressing and holding the
button for more than 3 seconds will reset the run time counter to zero
and restart the run time cycle from the beginning.

The horn (if programmed) will honk once;

The parking lights will flash slowly 3 times then remain lit.
To stop the vehicle at any moment, simply press the
procedure can only be carried out once per remote start.
Example: If your Module is programmed for a runtime of 3 minutes and your
vehicle has been running for 2 minutes already, pressing the
will reset the counter to zero and the Engine will run for another cycle (in this
case, 3 minutes).

Disable/Enable LED flashing


To disable the LED: Press
until the parking lights flash three times.

To Enable the LED: Press and
parking lights flash once.
User guide
button until the parking lights flash 3 times.
button until the parking lights come ON for
button, then, pressing and holding
and
simultaneously until the
button. This
button
simultaneously
P.17