Directed SMARTSTART ASRA-2510 User Manual page 10

To set the system to Ready Mode:
If Ready Mode is enabled by remote
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear
selector is in the neutral position.
2. With the engine already running,
apply the parking brake once and
release the brake pedal.
3. Within 20 sec. of engaging the
parking brake, press and hold
LOCK, UNLOCK or START/STOP
on the transmitter (SmartStart™
uses only START/STOP).
The parking lights will flash 3 times
quickly and remain lit.
4. Remove the key: the engine will keep on running.
5. Exit the vehicle. All doors should be closed, including the hood and trunk.
NOW THERE ARE THREE POSSIBLE OPTIONS
OPTION 1:
No Lock
The engine stops.
WARNING: The
vehicle is not armed or
locked down.
6. The Parking lights will flash.
LOCK:
P.10
Manual Shutdown
The engine keeps going until
you press either;
 LOCK to lock the doors
and shut down the
engine;
 UNLOCK to unlock the
doors and shut down the
engine;
 STAR/STOP to shut down
the engine without
affecting the doors.
WARNING: Engine runs
until the pre-programmed
run time expires.
UNLOCK:
If Ready Mode is enabled by
handbrake
2. With the engine already running,
apply the parking brake twice within
10sec.
3. Make sure to release the brake
pedal.
The parking lights will flash 3 times
quickly and remain lit.
OPTION 2:
(default)
START/STOP:
OPTION 3:
Automatic Shutdown
The engine runs for
8 sec. then locks the
doors before finally
shutting down the
engine, without user
interaction.
WARNING: Do not
leave your keys in the
vehicle!
TRUNK:
User Guide