Adding Expansion Cabinets - Cablescan 90 Series Setup Manual

Series 90 Setup Manual
7. Connect female end of the short (1 foot) 9-conductor cable (part number 9100086) to
bottom connector of Expansion Input/Output Board (COM IN); connect male end to
serial communication port (COM1).
8. Connect female end of 9-conductor cable (part number 9100069) to top connector of
Expansion Input/Output Board (EXPANSION); connect male end to INPUT
connector on the expansion cabinet.
9. Connect terminating plug (part no. 5211116) to OUTPUT connector on expansion
cabinet.
Make sure that all interface cables are secured with their mounting
screws. The most common source of trouble is poor connections.

Adding Expansion Cabinets

1. To add a second expansion cabinet, remove terminating plug from OUTPUT
connector on the first expansion cabinet.
2. Connect the female end of another 9-conductor cable (part number 9100069) to the
OUTPUT connector of first expansion cabinet, and male end to INPUT connector on
second cabinet.
3. If the second cabinet is the last in the chain, connect the terminating plug to its
OUTPUT connector. (The terminating plug is attached only to the last expansion
cabinet.)
Install Terminating Plug
on output connector of
last expansion cabinet
J8
2
J6
J4
J2
J8
J6
J4
J2
Figure 8. Multiple Expansion Cabinet Hookup
NOTE
J7 J18
J5 J16
J3
J14
J1 J12
OUTPUT INPUT
J10
1
J7 J18
J5 J16
J3 J14
J1
J12
OUTPUT INPUT
J10
MOUSE
USB
MONITOR
KB
J17
J15
J13
J11
J9
J17
J15
J13
J11
J9
ETHERNET
SPRK
Page 9