Series 90/90Hv Connection Procedure; Basic System Hookup - Cablescan 90 Series Setup Manual

Page 8

SERIES 90/90HV CONNECTION PROCEDURE

Basic System Hookup

Arrange the Series 90/90HV with the system controller alongside the expansion cabinet.
Connect the system as shown in Figure 7, and as described below:
1. Connect power cord (part number 9200016) from INPUT power connector (male) on
rear panel of expansion cabinet to AC receptacle.
2. Connect power cord (part number 9200016) from INPUT power connector (male) on
rear panel of system controller to AC receptacle.
3. Connect LCD monitor power cord from INPUT power connector (male) on color
monitor to AC receptacle. (The color monitor may have an attached cord.)
4. Connect keyboard to bottom PS/2 connector (KB) on System Controller.
5. Connect mouse to top PS/2 connector (MOUSE) on System Controller.
6. Connect VGA monitor to High-density 15-pin D connector (Monitor) on System
Controller.
Figure 7. Series 90/90HV Cable Connections
Series 90 Setup Manual