Overview - Valor L1 1600KN Installation Manual

Installation Planning
Note: This appliance may be installed in outdoor, weather protected environments
as defi ned in the GV60CKO Outdoor Conversion Kit instruction manual.
Remote Handset Wall
Holder
Surrou nd d Plate l with i h
Barr r ier Screen (required)
Narro o w 1" Trim 1575LFB and
wider 3-1/2" steel Trim 1550
adjust t able, accept additional
non-c c ombustible fi nish over
cement board and
behind trim. 1530CIK's
narrow trim requires
HeatShift.
Ceme e nt board finishes up to
perimeter of trim.
Note: 1 1 530CIK installs before
cem ce cem ent ent e t board bo bo ard a d.
Wall Finish
Any wall fi nishes applied
over cement board must
be non-combustible.
Combustible mantel are
o o k provided they conform
to chart
(see page 11)
Combustible Floor
WARNING
Some materials or items, although safe,
may discolor, shrink, warp, crack, peel,
and so on because of the heat produced
by the fireplace. Avoid placing candles,
paintings, photos, and other items
sensitive to heat around the fireplace.
10
. .
Supplied as horizontal side outlet, fi eld
convertible to top vertical outlet.
Framing—See Framing Requirements
1/2 inch thick non-combustible cement
board – NOT supplied
Optional LDK HeatShift Duct Kit outlets (4)
Combustible Framing Allowed Beneath Fireplace. When the appliance is
installed directly on carpeting, tile or other combustible material other
than wood fl ooring, the appliance shall be installed on a metal or wood
panel extending the full width and recessed depth of the appliance.
WARNING
HOT WALL SURFACES! The wall directly
above the fireplace is constructed of non-
combustible materials and, although safe,
it may reach temperatures in excess of
200°F (93°C) depending on choice of trims.
Do not touch. Finish wall using materials
suitable for these temperatures.

Overview

Remote Battery
and Wall Switch
1600K heater
Kit (required) (35-
foot wire length)
(supplied)
Electrical box for
optional WiFi