Table of Contents
Advertisement
Installation
4. Place log L12 onto the corner of the burner as
shown. It should not touch the pilot light.
L2
L12
5. Place log L31 across the platform as shown with the
pin inserted in the front hole as shown. A small
amount of embers should be placed into the burner
as shown to lift the front of the log slightly.
6. Place log L6 from the rear groove on the top of L31
to the rear of the media platform.
L6
36
L30
L31
Embers
Groove
L31
7. Place log L1 from the front groove on the top of L31
and onto the front of the media platform.
L6
8. Place log L32 with its bottom cutout around the
front corner of the burner.
9. Place log L4 on the groove on the top of L32 and
across the burner to the rear platform.
10. Place (do not pour) embers by hand on the burner
and media platform.
Fuel Beds
Groove
L1
L31
L32
Groove
L4
L32
Advertisement
Table of Contents
