Table Of Contents; Introduction; Disconnect And Lock-Out Procedures - Signode MCD-710 Operation, Parts And Safety Manual

General Safety Instructions
Introduction
Disconnect and Lock-out Procedures
Specifications
Installation and Major Components
Priciples of Operation
Maintenance and Lubrication
Electric:
! Sequence, MCD (Std.)
Diagram, MCD (Std.)
!
! Sequence, MCD (w/ Oper. Int.)
! Diagram, MCD (w/ Oper. Int.)
! Control Panel
Machine:
! Parts List, Removal & Replacement 16
Micro Switch Adjustment
!
! Covers & Signs
Recommended Spare Parts
!
! Troubleshooting
Modular Chute:
General Information
!
! Parts List
! Optional Chute Support
! Troubleshooting
Dispenser:
! Loading and Threading
! Adjustments
! Parts List
Conversion
!
Machine Options

INTRODUCTION

The placement of the welding head on the
side of the MCD makes possible a lower
conveyor height, an easier fit into an existing
conveyor system, handier servicing, and
locates the weld where it is more convenient
to pull open. The MCD automatically makes a
strong weld in Contrax® or Tenax® co-
polymer strapping, joining the ends without
seals, adhesives, or solvents, and without
applied heat or electricity. The process
utilizes Tension-Weld®, is clean - no smoke
or odor, no grit to cause wear, no heaters to
carbonize. Tension-Weld is a development so
unique that the process, machine and weld
have been patented.
2 DISCONNECT AND LOCK-OUT
PROCEDURES
4
DISCONNECT SWITCH
4
The main disconnect switch is located on the
5 front of the electrical enclosure.
6
7
9
10
11
12
13
14
24
To disconnect/lock-out electrical power to
28
30 the machine, proceed as follows:
31
P Switch the main disconnect switch to the
OFF position.
35
38
P Locate an appropriate locking hole on the
43
switch, more than one may be provided,
44
and apply a locking device.
46
47
48
50
51
P Confirm that power has been
disconnected by pulling out machine start
button (return button to stop position).
4
For Parts & Service 1-877-862-6699