Signode MCD-710 Operation, Parts And Safety Manual page 34

TROUBLESHOOTING, Continued
#9 SYMPTOM: Double welding. Immediately after completing cycle machine goes into another weld
cycle.
CAUSE
Drop-out arm (159) is stuck in open position.
#10 SYMPTOM: Strap escapes from stretch-out box during take-up.
CAUSE
1. Too much strap being taken up.
2. Strap does not accumulate in stretch-out box.
#11 SYMPTOM: Low or erratic tension.
CAUSE
Slip clutch set too high.
Make sure drop-out arm is free and its pivot pin is
lightly lubricated. Do not get lubricant on tension
wheel (170).
1. Check package to chute ratio. Ratio should not
exceed 5:1.
2. Strap is too stiff, add strap snubber kit
#185298 to stretch-out box.
Adjust slip clutch nut (54).
34
For Parts & Service 1-877-862-6699
REMEDY
REMEDY
REMEDY