Loading The Driver At Server Bootup - Adaptec P2280A Manual

Ultra160 Family Manager Set User's Guide

Loading the Driver at Server Bootup

To automatically load the adpt160m.ham at server bootup, the
startup.ncf file (usually located in your server's startup directory)
must contain a load command line that specifies the location of the
driver and any appropriate command line options (see Using the
Load Command Line Options on page 4-9). For additional information
on the startup.ncf file, refer to your NetWare documentation.
The correct syntax to load the driver is
load [ pathname ]adpt160m.ham [ options ]
For example, the command line to load the driver from the
c:\nwserver directory, with the verbose= option on is
load c:\nwserver\adpt160m verbose=y
Command line options are not case sensitive. Placing commas
between command line options is optional. See Using the Load
Command Line Options on page 4-9 for possible values.
To modify the startup.ncf file, follow these steps:
Note:
You can also use your DOS text editor to modify the
startup.ncf file.
1
Type load install at the NetWare prompt and press Enter.
2
Select the appropriate menu choice that allows you to edit the
startup.ncf file.
3
Make the necessary changes. When you are done, press Esc.
4-8