Using The Load Command Line Options; Adpt160M.ham Command Line Options - Adaptec P2280A Manual

Using the Load Command Line Options

You can specify several command line options when the driver is
loaded. The available options are described in the table below. This
table describes command line options for the adpt160m.ham driver
for Ultra160 products.

adpt160m.ham Command Line Options

Option Values
auto_disable_tagq= on, off
dev_enable= 0-FFFF
flush_diskreq= 0-FFFF
instr= on, off
Novell NetWare Installation
Default Description
off Enables/disables auto
disable tagged queuing
algorithm.
FFFF Allows you to enable the
driver's registration of
SCSI devices on a per
target basis. By default, all
targets are scanned. A bit
value of 0 causes the
target not to register
under the operating
system. These devices are
still accessible via ASPI.
This enable bit mask is
entered in hex (see Bit
Mask Options on
page 4-11).
0 A bit mask to send
occasionally ordered tags
to specific targets. By
default, no targets receive
occasionally ordered tags.
This bit mask is entered in
hex (see Bit Mask Options
on page 4-11).
off Enables/disables
recording of I/O statistics.
4-9