Using A Cd-Rom With Netware - Adaptec P2280A Manual

Ultra160 Family Manager Set User's Guide
2
When sbackup is loaded, it asks for a login name. Enter the
appropriate name.
3
If sbackup asks you to select the device driver, select the HP
DIBI-2 Tape Driver, regardless of the type of SCSI tape drive
being attached (e.g., even if the tape drive is manufactured by
Wangtek, do not select the Wangtek driver).
Note:
Novell also includes a driver called adaptec.nlm .
This driver is not needed and should not be loaded.
Adaptec's driver module takes advantage of ASPI
interface features bypassed by adaptec.nlm .
Novell publishes a list of SCSI tape drives supported by
sbackup.nlm .

Using a CD-ROM with NetWare

To use a CD-ROM with NetWare, follow these instructions:
1
Load adpt160m.ham by entering the following line:
:load [ pathname ]adpt160m
2
The scsicd.cdm driver will auto-load if the device(s) are
detected.
Note:
For multiple LUN CDs, enable multiple LUN
scanning with the lun_enable switch (e.g., load
adpt160m lun_enable=FF). The lun_enable switch is
needed for adpt160m.ham .
Enter the following line at the prompt:
scan all luns
4-14