Installing The Driver When Netware Is Already Installed - Adaptec P2280A Manual

Installing the Driver When NetWare is Already
Installed
To update or install the adpt160m.ham driver when NetWare is
already installed, follow the instructions in this section. The
procedures are similar for all versions of NetWare. Procedures that
are specific to a NetWare version are noted when necessary.
1
Make a backup copy of the old driver (if it exists) before
installing the new driver.
2
Copy the adpt160m.ham driver from the Ultra160 Family
Manager Set disk for NetWare into the server's startup
directory (e.g., c:\nwserver, c:\server.40 ) on your hard disk.
This overwrites any existing version of the driver in the
directory.
Note:
For NetWare 3.12/3.2 and 4.12/4.2, the file is in
\netware . For NetWare 5.0, the file is in \netware\v5_xx
3
If necessary, modify the load command line in the startup.ncf
file so that the proper path to the driver and all appropriate
command line options are specified. See Loading the Driver at
Server Bootup on page 4-8.
The correct syntax to load the Ultra160 Family driver is
load [ pathname ]adpt160m [ options ]
Command line options are not case sensitive. Placing commas
between command line options is optional. See Loading the
Driver at Server Bootup on page 4-8 for possible values.
Novell NetWare Installation
4-7