Test Indicators; Sirens Test; Test Devices - Rosslare HOME LOGIX HLX-24 Hardware Installation And Programming Manual

Installer Menu
To perform the test:
1. Using Menu select the test you wish to perform, and press Enter to
access the test.
2. Activate the RF unit to send a signal to the unit. The results can be
Normal Low
or
Test Detectors (Walk Test) (refer to Table 11)

 Test R. Controls
 Test R. Siren
 Test Keypads
 Test Repeaters
To v iew the results:
For each of the tests, you can review the results by pressing Enter and
1.
then either Menu or the alphanumeric keys review all the units.
To exit the RF test mode you must press ESC.
2.
6.8.3

Test Indicators

The indicators test checks the two indicator LEDs, power and status, located on
the Panel.
To test the indicators:
After entering this menu, press Enter. The LEDs blink three times.
6.8.4

Sirens Test

This test checks the different available sirens by activating them.
To test the sirens:
1. Select the siren you wish to test:
 Local Siren
Wireless siren

 Siren 1
 Siren 2
 Siren 3
 Siren 4
2. Press Enter to activate the sounder.
3. Press ESC to stop the siren.
6.8.5

Test Devices

This test checks the PGM connected to the system.
To test the PGM dev ices:
1. Select the PGM test
2. Press Enter to activate the PGM for three seconds.
50
. The available tests are:
HLX-24 Hardware Installation and Programming Manual
Strong
,