Alarm Abort Time; Backlight Time; Hide Display - Rosslare HOME LOGIX HLX-24 Hardware Installation And Programming Manual

Installer Menu
For a signal to be sent to the CMS, the Alerts reporting group must be enabled
in Report Options (Section 6.5.3).
To set the Alarm Cancel:
1. Using the numeric keypad, set the alarm cancel time between 01 to 10
minutes or 00 to disable the option.
2. Press Enter to confirm.
6.4.19

Alarm Abort Time

The system sounds a warning, but the central station does not receive
notification of the alarm if the user disarms the system within the specified
alarm abort time. This function applies to interior, perimeter, and 24-hour
Alarm Abort Time
zones. The default
To set the alarm abort time:
1. Using the numeric keypad, set the alarm abort time between 01 to 45
seconds or 00 to disable the option.
2. Press Enter to confirm.
6.4.20

Backlight Time

Specifies the backlight options; by default, the backlight time is set to 15
seconds.
To set the backlight:
Using Menu, select one of the following options:
1.
Always: to specify that the keypad and buttons are backlit at all

times.
15 secs: to specify that the keypad and buttons are backlit for up to

15 seconds after last key press.
Press Enter to confirm.
2.
6.4.21

Hide Display

Enables you to specify that when armed, the system does not display the
system statuses or other system prompts; by default,
To display the sy stem status:
1. Using Menu, select one of the following options:
 Off to display status and prompts.
 On to hide status and prompts.
2. Press Enter to confirm.
HLX-24 Hardware Installation and Programming Manual
is 30 seconds.
Hide Display
is off.
37