Dell PowerEdge E31S Series Owner's Manual page 53

Hide thumbs Also See for PowerEdge E31S Series:
Table of Contents

Advertisement

Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
Steps
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click SATA Settings.
Related references
SATA Settings
on page 52
Related tasks
SATA Settings details
on page 53
SATA Settings details
About this task
The SATA Settings screen details are explained as follows:
Option
Description
Embedded SATA
Enables the embedded SATA option to be set to Off, ATA, AHCI, or RAID modes. This option is set to
AHCI by default.
Security Freeze
Sends Security Freeze Lock command to the Embedded SATA drives during POST. This option is
Lock
applicable only for ATA and AHCI modes.
Write Cache
Enables or disables the command for Embedded SATA drives during POST.
Port A
Sets the drive type of the selected device. For Embedded SATA settings in ATA mode, set this field to
Auto to enable BIOS support. Set it to OFF to turn off BIOS support.
For AHCI or RAID mode, BIOS support is always enabled.
Option
Model
Drive Type
Capacity
Port B
Sets the drive type of the selected device. For Embedded SATA settings in ATA mode, set this field to
Auto to enable BIOS support. Set it to OFF to turn off BIOS support.
For AHCI or RAID mode, BIOS support is always enabled.
Option
Model
Drive Type
Capacity
Description
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
Specifies the total capacity of the hard drive. This field is undefined for removable
media devices such as optical drives.
Description
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
Specifies the total capacity of the hard drive. This field is undefined for removable
media devices such as optical drives.
Pre-operating system management applications
53

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Poweredge r730E31s001

Table of Contents