Dell PowerEdge E31S Series Owner's Manual page 52

Option Description
processor cores to transition into a lower power idle state. This option can only be enabled if the
operating system supports it. It is set to Disabled by default.
Configurable TDP Enables you to reconfigure the processor Thermal Design Power (TDP) levels during POST based on the
power and thermal delivery capabilities of the system. TDP verifies the maximum heat the cooling system
is needed to dissipate. This option is set to Nominal by default.
X2Apic Mode Enables or disables the X2Apic mode.
Dell Controlled Controls the turbo engagement. Enable this option only when System Profile is set to Performance.
Turbo
Number of Cores Controls the number of enabled cores in each processor. This option is set to All by default.
per Processor
Processor 64-bit Specifies if the processor(s) support 64-bit extensions.
Support
Processor Core Specifies the maximum core frequency of the processor.
Speed
Processor 1
The following settings are displayed for each processor installed in the system:
Option
Family-Model-
Stepping
Brand
Level 2 Cache
Level 3 Cache
Number of Cores Specifies the number of cores per processor.
Related references
Processor Settings on page 50
Related tasks
Viewing Processor Settings
SATA Settings
You can use the SATA Settings screen to view the SATA settings of SATA devices and enable RAID on your system.
Related references
System BIOS on page 38
Related tasks
SATA Settings details on page 53
Viewing SATA Settings on page 53
52 Pre-operating system management applications
NOTE: This option is only available on certain stock keeping units (SKUs) of the processors.
NOTE: Depending on the number of installed CPUs, there may be up to four processor listings.
NOTE: Depending on the number of CPUs, there may be up to four processors listed.
Description
Specifies the family, model, and stepping of the processor as defined by Intel.
Specifies the brand name.
Specifies the total L2 cache.
Specifies the total L3 cache.
on page 51