Installing The Cable Retention Bracket - Dell PowerEdge E31S Series Owner's Manual

Removing the cooling shroud

Installing the cable retention bracket

Installing the cooling shroud
Installing the PCIe card holder
After working inside your system
Installing the cable retention bracket
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the cooling shroud.
4. Remove the PCIe card holder.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
Steps
1. Align the cable retention bracket with the alignment pins on the chassis.
2. Slide the cable retention bracket along the chassis wall until the tab clicks and locks the keyhole slots.
3. Place all cables to be routed in the cable retention bracket.
Figure 42. Installing the cable retention bracket
1. alignment pin (2)
3. tab
Next steps
1. Install the PCIe card holder.
2. Install the cooling shroud.
3. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 66
Related tasks
Before working inside your system
on page 74
on page 101
on page 75
on page 98
on page 67
on page 67
2. keyhole slot
4. cable retention bracket
Installing and removing system components 101