Inch Hard Drive Chassis - Dell PowerEdge E31S Series Owner's Manual

2.5 inch hard drive chassis

Figure 3. Front panel features (2.5-inch hard drive/SSD chassis)
1. Power button
3. System identification button
5. LCD menu buttons
7. LCD panel
9. vFlash media card slot
11. USB management port/iDRAC Direct
13. Tape drive slot
Table 2. Front panel features (2.5-inch hard drive/SSD chassis)
Item Indicator, button, or
connector
1 Power button
2 NMI button
3 System identification button
12 Dell PowerEdge R730 system overview
2. NMI button
4. Video connector
6. Information tag
8. Hard drives
10. USB port
12. Optical drive
14. Quick Sync
Icon Description
Enables you to know the power status of the system. The
power indicator turns on when the system power is on. The
power button controls the power supply output to the system.
NOTE:
power button is used to shutdown the system, the
operating system performs a graceful shut down the
system power is turned off.
Enables you to troubleshoot software and device driver errors
when running certain operating systems. This button can be
pressed by using the end of a paper clip.
NOTE:
qualified support personnel or by instructions in the
operating system's documentation.
Enables you to locate a particular system within a rack.
The identification buttons are located on the front and back
panels.
Press the system identification button to turn the system ID
on or off.
NOTE:
● If the system stops responding during POST, press
and hold the system ID button (for more than five
seconds) to enter BIOS progress mode.
● To reset the iDRAC (if not disabled in F2 iDRAC setup)
press and hold the button (for more than 15 seconds).
On ACPI compliant operating systems, when the
Use this button only if directed to do so by