Table of Contents
Advertisement
bandwidth in
[Value]
bandwidth out
[Value]
show bandwidth
state
[Enable | Disable]
show interface configuration
show interface status
show interface accounting
no accounting
I
Set interface input bandwidth.
Rate Range is from 100 kbps
to 102400 kbps or to 256000
kbps for giga ports,
and zero means no limit.
Set interface output
bandwidth. Rate Range is
from 100 kbps to 102400 kbps
or to 256000 kbps for giga
ports,
and zero means no limit.
I
Show interfaces bandwidth
control
I
Use the state interface
configuration command to
specify the state mode of
operation for Ethernet ports.
Use the disable form of this
command to disable the port.
I
show interface configuration
status
I
show interface actual status
I
show interface statistic
counter
I
Clear interface accounting
information
122
User's Manual of ISW-1022M
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth in 100
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth out 100
switch(config)#interface fastEthernet 2
switch(config-if)#show bandwidth
switch(config)#interface fastEthernet 2
switch(config-if)#state Disable
switch(config)#interface fastEthernet 2
switch(config-if)#show interface
configuration
switch(config)#interface fastEthernet 2
switch(config-if)#show interface status
switch(config)#interface fastEthernet 2
switch(config-if)#show interface accounting
switch(config)#interface fastEthernet 2
switch(config-if)#no accounting
Advertisement
Table of Contents
