2.2.2 DIN-Rail Mounting
The DIN-Rail is screwed on the Industrial Switch when out of factory. If the DIN-Rail is not screwed on the Industrial
Switch, please see the following pictures to screw the DIN-Rail on the switch. Follow the steps below to hang the Industrial
Switch.
1.
First, insert the top of DIN-Rail into the track.
2.
Then, lightly push the DIN-Rail into the track.
Figure 2-4 Rear Panel – DIN-Rail Kit
Figure 2-5 DIN-Rail Mounting
17
User's Manual of ISW-1022M