Table of Contents
Advertisement
5.4.8 IP Security
IP security function allows the user to assign 10 specific IP addresses that have permission to manage the switch through
the http and telnet services for the securing switch management. The purpose of giving the limited IP addresses
permission is to allow only the authorized personnel/device can do the management task on the switch.
The page includes the following fields:
Object
IP Security Mode:
Enable HTTP Server:
Enable Telnet Server:
Security IP 1 ~ 10:
Figure 5-16 IP Security interface
Description
Having set this selection item in the Enable mode, the Enable HTTP Server,
Enable Telnet Server checkboxes and the ten security IP column fields will then
be available. If not, those items will appear in grey.
Having ticked this checkbox, the devices whose IP addresses match any one of
the ten IP addresses in the Security IP1 ~ IP10 table will be given the permission
to access this switch via HTTP service.
Having ticked this checkbox, the devices whose IP addresses match any one of
the ten IP addresses in the Security IP1 ~ IP10 table will be given the permission
to access this switch via telnet service.
The system allows the user to assign up to 10 specific IP addresses for access
security. Only these 10 IP addresses can access and manage the switch through
the HTTP/Telnet service once IP Security Mode is enabled.
User's Manual of ISW-1022M
52
Advertisement
Table of Contents
