Rs232 Serial Communication - Ametek BrookField TC Series Operator's Manual

NOTE: To conserve power when not in use, the LCD's backlighting will go out about 5 seconds after
"Standby" appears. The Power Key will remain lit to indicate that the Controller is energized and ready
to use.
IEC Power Connection to
Refrigeration Power Module
IEC to IEC Power Cord
Power Switch / Circuit Breaker
Heat Only Circulators
Attach the 6-ft / 1.8 m power cord to the IEC electrical connection on the Temperature Controller and then
plug the male connector into the Mains electrical outlet.
Place the Power Switch / Circuit Breaker on the Temperature Controller in the ON position. The LCD on
the Controller will light and "Standby" will appear on the display; the Power Key will also light.
NOTE: To conserve power when not in use, the LCD will go black about 5 seconds after "Standby"
appears. The Power Key will remain lit to indicate that the Controller is energized and ready to use.

RS232 Serial Communication

CAUTION: Always turn electrical power to the Circulator OFF before making a connection to the
serial (DB9) port.
Your Circulator features RS232 serial communication for remote data logging and control capability. A 9-
pin female D-connector is provided on the rear of the Temperature Controller for this purpose.
The serial interface should be connected to a serial communication port on a remote PC using an
appropriate cable. Information on the RS232 command and communication protocol can be found in the
Technical Information section of this manual.
110-512 BEL/EN
Refrigeration Power Module
IEC Power Connection to Controller
IEC Power Connection to Mains
IEC to Mains Power Cord
19