Refrigeration Control Connections (Refrigerating/Heating Circulators Only); Electrical Power - Ametek BrookField TC Series Operator's Manual

Refrigeration Control Connections
Attach the Refrigeration Control Cable to the Refrigeration Control Connections on the rear of the
Temperature Controller and the Refrigeration Power Module.

Electrical Power

WARNING: The Circulator's power cord must be connected to a properly grounded electrical
receptacle. Make certain that this electrical outlet is the same voltage and frequency as your
Circulator. The correct voltage and frequency for your Circulator are indicated on the identification
label on the back of the Controller.
CAUTION: The use of an extension cord is not recommended. If one is necessary, it must be
properly grounded and capable of handling the total wattage of the unit. The extension cord must not
cause more than a 10% drop in voltage to the unit.
Refrigerating / Heating Circulators
Attach the 3-ft / 0.91 m power cord to the IEC electrical connectors on the Temperature Controller (male)
and the Refrigeration Power Module (female).
Attach the 6-ft / 1.8 m power cord to the IEC electrical connection on the Refrigeration Power Module and
then plug the male connector into the Mains electrical outlet.
Place the Power Switch / Circuit Breaker on the Refrigeration Power Module in the ON position. The LCD
on the Controller will light and "Standby" will appear on the display; the Power Key will also light.
110-512 BEL/EN
(Refrigerating/Heating Circulators only)
Refrigeration Control Connection
Refrigeration Control Cable
Refrigeration Control Connection
18