Changing Your Circulator's Viewing Angle; Loss Of Power Restart; Inert Gas Purge - Ametek BrookField TC Series Operator's Manual

Circulating baths with standard digital temperature controller

Table of Contents

Changing Your Circulator's Viewing Angle

Your Circulator is equipped with Swivel 180™, an innovative feature which permits viewing of the

temperature display from anywhere over a 180° arc.

There are positive stops at 45° intervals; however, the viewing angle may be set

NOTE:

anywhere within a 180° arc.

To change the viewing angle, slide the release latch to the right and rotate the Temperature Controller to

the desired angle. The latch release will automatically return to the locked position at every 45° positive

stop.

WARNING: The unit will start automatically after a disruption in electrical power.

In the event that electrical power is lost while your Circulator is in use, it will begin operating automatically

once power is restored. FAIL POWER will appear on the display to alert you that there was a power

disruption. To clear the message, turn the Circulator OFF and then back ON again using the

NOTE: The FAIL POWER message will also appear if the Circulator is turned OFF and then back ON

using only the Power Switch / Circuit Breaker on the rear of the unit.

A 0.125 in. / 3 mm port on the rear of the Temperature Controller is provided to allow you to blanket the

surface of the liquid in the bath reservoir with nitrogen or another inert gas to help prevent condensation

and dilution of the bath fluid.

110-512 BEL/EN

Swivel 180™ Latch Release

FAIL POWER

Alerts you to a temporary

loss of electrical power

key.

Table of Contents