Programming Additional Transmitters; Deleting Transmitters - Becker C01a Assembly And Operating Instructions Manual

Deleting the desired intermediate position

Programming additional transmitters

In addition to the master transmitter, up to 15 further transmitters can be programmed in
the tubular drive.

Deleting transmitters

Deleting individual transmitters
The programmed master transmitter cannot be deleted. It can only be overwritten (see
Programming the master transmitter [} 13]).
18
Move the shading solution to the intermediate position that is to be deleted.
Now press the STOP button and, within 3 seconds, also press the travel button as-
signed to the intermediate position and hold the two buttons down.
▻ The tubular drive acknowledges.
► The intermediate position is now deleted.
Press the programming button of the master transmitter for 3 seconds.
▻ The tubular drive acknowledges.
Now press the programming button of a new transmitter which has not yet been pro-
grammed in the tubular drive for 3 seconds. Doing so activates the programming
mode of the tubular drive for a new transmitter for 3 minutes.
▻ The tubular drive acknowledges.
Now press the programming button of the new transmitter you wish to program again
for 3 seconds.
▻ The tubular drive acknowledges.
► The new transmitter has now been programmed.
Press the programming button on the master transmitter for 3 seconds.
▻ The tubular drive acknowledges.
Now press the programming button of the transmitter to be deleted for 3 seconds.
▻ The tubular drive acknowledges.
Then press the programming button of the transmitter to be deleted again for 10
seconds.
▻ The tubular drive acknowledges.
► The transmitter is now deleted from the tubular drive.