Programming the master transmitter
If a transmitter is already programmed on the receiver, press the programming button for
10 seconds.
Checking that the running direction is correct
There are 2 ways to change the direction of rotation:
• Changing direction of rotation via rotation direction switch
• Changing direction of rotation via master transmitter
Changing direction of rotation via rotation direction switch
Press the UP or DOWN button
▻ The shading solution runs in the desired direction
► The running direction is OK.
If the shading solution runs in the wrong direction, the running direction must be changed. Proceed as follows:
Readying the tubular drive for programming with the radio switch
Switch the radio switch to the inside position. If the radio switch is already in this posi-
tion, switch it to the outside and back to the inside position.
► The tubular drive is ready to programme for 3 minutes
Press the programming button for 3 seconds when it is ready to programme.
▻ The tubular drive acknowledges.
► The programming process is now complete.
Switch the direction switch (1) to the opposite position.
▻ The running direction will now have changed.
► Check the running direction again.
13