Intermediate Positions I + Ii - Becker C01a Assembly And Operating Instructions Manual

Deleting individual limit positions
Deleting both limit positions

Intermediate positions I + II

The intermediate positions I + II are freely selectable positions for the shading solution
between the two limit positions. Each travel button can be assigned one intermediate posi-
tion. Both limit positions must be set before an intermediate position is set.
Setting the desired intermediate position
Travelling to the desired intermediate position
Open/close to the limit position to be deleted.
Press the programming button and, within 3 seconds, also press the STOP button
and hold the two buttons down for 10 seconds.
▻ The tubular drive acknowledges.
► The limit position is now deleted.
Open/close the shading solution to a point between the limit positions.
Press the programming button and, within 3 seconds, also press the STOP button
and hold the two buttons down for 10 seconds.
▻ The tubular drive acknowledges.
► The limit positions are now deleted.
Open/close the shading solution to the desired intermediate position.
Press the STOP button and, within 3 seconds, also press the desired travel button
and hold the two buttons down.
▻ The tubular drive acknowledges.
► The intermediate position is now saved.
Press the travel button for the desired intermediate position twice within one second.
► The curtain runs to the intermediate position assigned to the travel button.
17