Microcom 428LT Operator's Manual page 68

Chapter 5
011 – 3.25
111 – 4
7 Disable System Parameter Saving: When enabled, the printer will not save
the non-volatile system parameters on power downs. The ^A1^D143 will
continue to save system parameters.
8 Finish Mode: When enabled, the printer will finish printing the current label
as far as it can after a stock out error. The change will take place after a power
cycle or after the restart command. When a stock out occurs the printer will
finish printing the entire label if the LSY is less than the dot-to-gap distance. If
greater, it will continue printing for a distance equal to the dot to gap distance
OR until the label finishes; which ever comes first. The dot-to-gap value is
configurable using the D158 command. The error will be acknowledged at the
end of printing. This will work with all media (continuous, black line, and gap).
5.2.1.8 Software Switch #8
^AB ^D COMMAND
XX 28 Change SW8: Software Switch #8.
^AB12345678 (each bit is represented by a numeric position number)
Position:
1 Enable Test Ticket: When this position is enabled, the printer will execute
the saved format stored every time that the button is pressed. For more
information regarding saved formats, please refer to SW #2
2-6 NOT USED:
7 Enable Reflective Stock Out: For stock out detection while printing, the LCB
must be set for continuous stock (LCB=2) and sw8 p7 must be set. For power
up stock out detection (when sw6 p4 set) just sw8 p7 must be set (since there
may not be a valid LCB in play).
8 NOT USED:
428LT Operator's Manual - 880040-0200
1 = Disable system parameter saving
0 = Enable system parameter saving
1 = Enable Finish Mode
0 = Disable Finish Mode
1 = Disable Test Ticket
0 = Enable Test Ticket
1 = Disable system parameter saving
0 = Enable system parameter saving
Printer Commands
5-25