Advertisement
Your Yardistry structure is designed and constructed of quality materials. As with all outdoor
products it will weather and wear. To maximize the enjoyment, safety and life of your structure
it is important that you, the owner, properly maintain it.
HARDWARE:
•
Check metal parts for rust. If found, sand and repaint using a non-lead paint complying
with 16 CFR 1303.
•
Inspect and tighten all hardware after completion of assembly; after first month of use; and
then annually. Do not over-tighten as to cause crushing and splintering of wood.
•
Check for sharp edges or protruding screw threads, add washers if required.
WOOD PARTS:
•
Unprotected they will appear weathered over time. Periodic application of an exterior
water repellent or stain (water-based) will help improve appearance and life.
•
Check all wood members for deterioration, structural damage and splintering. Sand down
splinters and replace deteriorated wood members. As with all wood, some checking and
small cracks in grain is normal
Tools Required:
•
Tape Measure
•
Carpenters Level
•
Standard or Cordless Drill
•
#2 Phillips Bit or Screwdriver
•
7/16" Wrench or Socket
Symbols:
Throughout these instructions symbols are provided in the top, right-hand corner of the page.
•
Use Help, where this is shown, 2 or 3 people
are required to safely complete this step.
To avoid injury or damage to the assembly
make sure to get some help.
•
Pre-drill a pilot hole before fastening
screw or lag to prevent splitting of wood.
If you dispose of your Yardistry structure: Please disassemble and dispose of your
unit so that it does not create any unreasonable hazards at the time it is discarded. Be
sure to follow your local waste ordinances.
Instructions for Proper Maintenance
Assembly Guides
•
•
•
•
•
8' Step Ladder
Safety Glasses
Adult Helper
Gloves
Hard Hat
•
Use a measuring tape to assure proper
location
4
support@yardistrystructures.com
Advertisement
