Yardistry YM11700 Installation And Operating Instructions Manual page 24

Step 8: Assemble Beam Ends
A: On a flat and level surface attach one
(069) Beam End 10-1/2" to (192) Beam
End 34-1/4" with three #10 x 4" Wood
Screws as shown in fig. 8.1.
B: Repeat Step A three more times so
you have four assemblies. Note that two
of the Beam Ends should be on the same
side as the cut out and two should be on
the opposite side. (fig. 8.1 and 8.2)
#10 x 4" Wood
Screws
Wood Parts
4 x (192) Beam End 34-1/4" 38.1 x 139.7 x 870 mm (2 x 6 x 34-1/4")
4 x (069) Beam End 10-1/2" 38.1 x 139.7 x 266.7 mm (2 x 6 x 10-1/2")
Cut-out
(069) Beam
End 10-1/2"
10-1/2"
#10 x 4" Wood
Screws
(192) Beam
End 34-1/4"
Fig. 8.2
Two Beam
Ends attached
on cut-out side
Cut-out
(192) Beam
End 34-1/4"
12 x #10 x 4" Wood Screw
24
Fig. 8.1
Two Beam Ends
attached on
opposite side of
cut-out
(069) Beam
End 10-1/2"
10-1/2"
Hardware
support@yardistrystructures.com