Advertisement
Step 9: Attach Beams to Corner Post Assemblies
It is important the proper hardware gets
placed in the places shown. You install the
Hex Bolts first and then the screws.
A: Loosely attach one Beam End assembly
from Step 8 to each Corner Post assembly with
the cut-out side facing out using one 5/16 x
5" Hex Bolt (with 5/16" flat washer, 5/16" lock
washer and 5/16" T nut)
Note: Beams should be flush to top of posts.
Fig. 9.2
Beam End
Assembly
Flush
Wood Parts
2 x (234) Beam 105-1/2" 38.1 x 139.7 x 2679.7 mm
(234) Beam
105 1/2"
(234) Beam 105 1/2"
Flush
Beam End
Fig. 9.1
Assembly
Panel Post
Long
Cut-out
Beam End
Assembly
Hardware
12 x #8 x 3" Wood Screw
4 x 5/16 x 6" Hex Bolt (5/16" flat washer, 5/16" lock washer, 5/16" t-nut)
4 x 5/16 x 5" Hex Bolt (5/16" flat washer, 5/16" lock washer, 5/16" t-nut)
25
5/16 x 5
5/16 Lock
Hex Bolt
Washer
5/16 Flat
Washer
5/16 T-nut
#8 x 3"
Wood
Screw
5/16 x 6"
Hex Bolt
B: Fit one (234) Beam 105-1/2"
in between two Corner Post
Assemblies and attach to Beam
End assemblies and Panel Post
as shown in fig. 9.1 and 9.2 with
one 5/16 x 6" Hex Bolt. This bolt
is only used for hole alignment
at this point.
C: Attach six #8 x 3" Wood
Screws.
D: Repeat Steps A, B and C to
the opposite pair of Panel Corner
Post Assemblies to make a front
and back.
support@yardistrystructures.com
Advertisement
