Advertisement
Step 13: Attach Support Beams
Part 2
It is important the proper hardware gets placed in
the places shown.
B: Attach one (231) Support Beam to each Beam End
Assembly and (235) Engineered Panel Corner Post
Long by replacing the 5/16 x 6" Hex Bolt (lock washer
and flat washer) removed in Part 1. (fig 13.3 & 13.4)
Ensure the cut outs in the boards are interlocking as
shown in fig. 13.5.
C: Using two 5/16 x 3" Hex Bolts (with lock washer,
flat washer and t-nut) attach the interlocking cut outs
of (231) Support Beams to (234) Beam 105 1/2" as
shown in fig. 13.5.
Fig. 13.4
(235) Engineered
Panel Corner Post
Long
(231) Support Beam
Wood Parts
4 x (231) Support Beam 38.1 x 139.7 x 1866.9 mm
Beam End
Assembly
5/16 flat washer
(234) Beam 105 1/2"
5/16 lock washer
5/16 x 6" Hex Bolt
(previously removed)
Fig. 13.3
5/16" t-nut
Notice board
orientation
Hardware
4 x 5/16 x 3" Hex Bolt
(5/16 flat washer, 5/16 lock washer, 5/16" T-nut)
4 x 5/16 x 6" Hex Bolt (previously removed)
(5/16 flat washer, 5/16" lock washer & previously installed
5/16" T-nut)
31
Fig. 13.5
(231) Support
Beam
5/16 flat washer
5/16 lock washer
5/16 x 3" Hex Bolt
(231) Support
Beam
support@yardistrystructures.com
Advertisement
