System Servicing - Subaru 2006 Baja Owner's Manual

Table of Contents

Advertisement

Seat, seatbelt and SRS airbags
when the ignition switch is turned to the "ON" position.
The following components are monitored by the indi-
cator:
Front sub sensor (Right-hand side)
Front sub sensor (Left-hand side)
Airbag control module (including impact sensors)
Seatbelt pretensioner (Driver's side)
Seatbelt pretensioner (Passenger's side)
All related wiring
If the warning light exhibits any of the following
conditions, there may be a malfunction in the
seatbelt pretensioners and/or SRS airbag sys-
tem. Immediately take your vehicle to your
nearest SUBARU dealer to have the system
checked. Unless checked and properly re-
paired, the seatbelt pretensioners and/or SRS
airbag will not operate properly in the event of
a collision, which may increase the risk of inju-
ry.
Flashing or flickering of the warning light.
No illumination of the warning light when the
ignition switch is first turned to the "ON" posi-
tion.
Continuous illumination of the warning light.
1-26
Illumination of the warning light while driv-
ing.

System servicing

When discarding a seatbelt retractor assem-
bly or scrapping the entire vehicle damaged by
a collision, consult your SUBARU dealer.
Tampering with or disconnecting the sys-
tem's wiring could result in accidental activa-
tion of the seatbelt pretensioner and/or airbag
or could make the system inoperative, which
may result in serious injury. The wiring har-
nesses of the seatbelt pretensioner and SRS
airbag systems are covered with yellow insula-
tion and the connectors of the system are yel-
low for easy identification. Do not use electrical
test equipment on any circuit related to the
seatbelt pretensioner and airbag systems. For
required servicing of the seatbelt pretensioner,
see your nearest SUBARU dealer.

Advertisement

Table of Contents
loading

Table of Contents