Subaru 2006 Baja Owner's Manual page 109

Keys and doors
tomatically arm and doors will automatically lock.
To arm the system using power door locking
switches
1. Close all windows.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close the doors but leave only the driver's door or
the front passenger's door open.
6. Push the front side ("LOCK" side) of the power door
locking switch to set the door locks.
7. Close the door. An electronic chirp will sound once,
the turn signal lights will flash once, and the indicator
2-20
lights will start flashing rapidly. After rapid flashing for
30 seconds (standby time), the indicator lights will
then flash slowly (twice approximately every two sec-
onds), indicating that the system has been armed for
surveillance.
NOTE
The system can be armed even if the engine
hood, the windows and/or moonroofs are opened.
Always make sure that they are fully closed before
arming the system.
The 30-second standby time can be eliminated if
you prefer. Have it performed by your SUBARU
dealer.
The system is in the standby mode for a 30-sec-
ond period after locking the doors with the remote
transmitter. The security indicator light will flash
at short intervals during this period.
If any of the following actions is done during the
standby period, the system will not switch to the
surveillance state.
Doors are unlocked using the remote trans-
200889
mitter.
Any door is opened.
Ignition switch is turned to the "ON" position.
The engine does not start even when the igni-
tion switch is turned to the "START" position once
the alarm system has been triggered.