Activating And Deactivating The Alarm System; If You Have Accidentally Triggered The Alarm System; Arming The System - Subaru 2006 Baja Owner's Manual

Keys and doors
seconds.
The alarm is triggered by:
Opening a door
Turning the ignition switch to the "ON" position
Physical impact to the vehicle, such as forced entry
(only vehicles with shock sensors (dealer option))
Activating and deactivating the alarm
system
To change the setting of your vehicle's alarm system
for activation or deactivation, do the following.
1. Disarm the alarm system (see "Disarming the sys-
tem" in this section).
2. Sit in the driver's seat and shut all doors.
3. Turn the ignition switch to the "ON" position.
4. Hold down the UNLOCK side of the driver's power
door locking switch, open the driver's door within the
following 1 second, and wait 10 seconds without re-
leasing the switch. The setting will then be changed as
follows:
If the system was previously activated:
The horn sounds twice, indicating that the system is
now deactivated.
If the system was previously deactivated:
The horn sounds once, indicating that the system is
2-18
now activated.
NOTE
You may have the above setting change done by
your SUBARU dealer.
If you have accidentally triggered the
alarm system
To stop the alarm
Do any of the following operations:
Press any button on the remote transmitter.
Cycle the ignition switch from the "LOCK" to "ON"
position three times within 5 seconds.

Arming the system

Arming the system
To arm the system using remote transmitter
1. Close all windows and the moonroof (if equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close all doors.