Illuminated Entry; Vehicle Finder Function; Sounding A Panic Alarm; Selecting Audible Signal Operation - Subaru 2006 Baja Owner's Manual

Table of Contents

Advertisement

Illuminated entry

The interior dome light and ignition switch light will illu-
Illuminated entry
minate when the "
" button is pressed. These
lights stay illuminated for approximately 30 seconds if
any of the doors is not opened.
If the "
" button is pressed before 30 seconds have
elapsed, these lights will go out. Also, these lights will
go out if the key is inserted in the ignition switch. The
interior light switch must be set to the middle position
in order for this function to operate.

Vehicle finder function

Use this function to find your vehicle parked among
many vehicles in a large parking lot. Provided you are
within 30 feet (10 meters) of the vehicle, pressing the
"
" button three times in a five-second period will
cause your vehicle's horn to sound once and its turn
signal lights to flash three times.
NOTE
If the interval between presses is too short when
you press the "
" button three times, the sys-
tem may not respond to the signals from the re-
mote transmitter.

Sounding a panic alarm

To activate the alarm, keep the "
Sounding a panic alarm
for more than two seconds.
The horn will sound and the turn signal lights will flash.
To deactivate it, press any button on the remote trans-
mitter. Unless a button on the remote is pressed, the
alarm will be deactivated after approximately 30 sec-
onds.

Selecting audible signal operation

Using an electronic chirp, the system will give you an
audible signal when the doors lock and unlock. If de-
sired, you may turn the audible signal off.
Do the following to deactivate the audible signal. You
can also use the same steps to restore the function.
1. Sit in the driver's seat and shut all doors and the
rear gate.
2. Open the driver's door, then remove the key from
the ignition switch.
3. Hold down the "UNLOCK" side of the power door
locking switch.
4. While holding down the "UNLOCK" side of the pow-
er door locking switch, insert the key into the ignition
switch and remove it again at least 6 times within 10
seconds after Step 3.
5. While still holding down the "UNLOCK" side of the
Keys and doors
" button pressed
– CONTINUED –
2-9

Advertisement

Table of Contents
loading

Table of Contents