Abs Warning Light - Subaru 2006 Baja Owner's Manual

Table of Contents

Advertisement

Starting and operating

ABS warning light

The ABS warning light comes on when the ignition
switch is turned to the "ON" position and goes out after
approximately two seconds.
This is an indication that the ABS system is working
properly.
If the warning light behaves as follows, the ABS
system may not be working properly.
When the warning light is on, the ABS function
shuts down; however, the conventional brake
system continues to operate normally.
7-34
The warning light does not come on when the
ignition switch is turned to the "ON" position.
The warning light comes on when the ignition
switch is turned to the "ON" position, but it
does not go out even when the vehicle speed
exceeds approximately 8 mph (12 km/h).
The warning light comes on during driving.
If these occur, have the ABS system repaired at
the first available opportunity by your SUBARU
dealer.
NOTE
If the warning light behavior is as described in the
UB4010GA
following, the ABS system may be considered nor-
mal.
The warning light comes on right after the en-
gine is started but goes out immediately, remain-
ing off.
The warning light remains on after the engine
has been started, but it goes out when the vehicle
speed reaches approximately 8 mph (12 km/h).
The warning light comes on during driving, but
it goes out immediately and remains off.
When driving with an insufficient battery voltage such
as when the engine is jump started, the ABS warning
light may come on. This is due to the low battery volt-

Advertisement

Table of Contents
loading

Table of Contents