Windshield Wiper And Washer Switches - Subaru 2006 Baja Owner's Manual

Instruments and controls
blades.
NOTE
The wiper operates only when the ignition
switch is in the "ON" or "ACC" position.
Clean your wiper blades and window glass peri-
odically with a washer solution to prevent streak-
ing, and to remove accumulations of road salt or
road film. Keep the washer button depressed at
least for 1 second so that washer solution will be
sprinkled all over the windshield or rear window.
Grease, wax, insects or other material on the
windshield or the wiper blades results in jerky wip-
er operation and streaking on the glass. If you can-
not remove those streaks after operating the
washer or if the wiper operation is jerky, clean the
outer surface of the windshield or rear window
and the wiper blades using a sponge or soft cloth
with a neutral detergent or mild-abrasive cleaner.
After cleaning, rinse the window glass and wiper
blades with clean water. The glass is clean if no
beads form on the glass when you rinse with wa-
ter.
If you cannot eliminate the streaking even after
following this procedure, replace the wiper blades
with new ones. Refer to the "Replacement of wind-
3-26
shield wiper blades" section (chapter 11) for re-
placement instructions.

Windshield wiper and washer switches

Wiper and washer switches Windshield
Windshield wipers
1
1) MIST
To turn the wipers on, push the wiper control lever
down.
: Intermittent
LO: Low speed
HI: High speed
OFF
INT
LO
HI
UB3022BB