Abs Warning Light - Subaru 2006 Baja Owner's Manual

Instruments and controls
If the light comes on while driving, it is unnecessary to
stop the vehicle, but avoid driving up steep grades or
in stop and go traffic.
Automatic transmission control system warn-
ing
If the light flashes after the engine starts, it may indi-
cate that the automatic transmission control system is
not working properly. Contact your nearest SUBARU
dealer for service immediately.

ABS warning light

The ABS warning light comes on when the ignition
Warning lights Warning light Warning lights ABS Anti-lock Brake System ABS (Anti-lock Brake System)
switch is turned to the "ON" position and goes out after
approximatley two seconds.
This is an indication that the ABS system is working
properly.
If the warning light behaves as follows, the ABS
system may not work properly.
When the warning light is on, the ABS function
shuts down; however, the conventional brake
system continues to operate normally.
The warning light does not come on when the
ignition switch is turned to the "ON" position.
3-14
The warning light comes on when the ignition
switch is turned to the "ON" position, but it
does not go out even when the vehicle speed
exceeds approximately 8 mph (12 km/h).
The warning light comes on during driving.
If any of these conditions occur, have the ABS
system repaired at the first available opportuni-
ty by your SUBARU dealer.
(U.S.)
NOTE
(Canada)
If the warning light behavior is as described in the
following, the ABS system may be considered nor-
mal.
The warning light comes on right after the en-
gine is started but goes out immediately, remain-
ing off.
The warning light remains on after the engine
has been started, but it goes out when the vehicle
speed reaches approximately 8 mph (12 km/h).
The warning light comes on during driving, but
it goes out immediately and remains off.
When driving with an insufficient battery voltage such
as when the engine is jump started, the ABS warning
light may come on. This is due to the low battery volt-
age and does not indicate a malfunction. When the