Subaru 2006 Baja Owner's Manual page 342

agonally opposite the flat tire.
5. Take out the spare tire, jack, and wheel nut wrench.
Refer to the sections "Spare tire" and "Jack and tools"
in this chapter for their location, instructions and pre-
cautions.
After the spare tire is removed from the spare tire hold-
er, the cable must be wound up completely by turning
the hoist nut shaft clockwise until you hear a clicking
sound. Also visually inspect the cable to make certain
that there is no longer any slack present.
Removing the flat tire and installing the spare
tire
1. Loosen the wheel nuts using the wheel nut wrench
but do not remove the nuts.
0
1) Jack up point mark
2. Place the jack under the side sill at the front or rear
US9008BA
jack-up point closest to the flat tire. Jack-up points are
In case of emergency
1
UB9088BB
– CONTINUED –
9-13