System Servicing - Subaru Legacy Outback 2006 Owner's Manual

1-24
Seat, seatbelt and SRS airbags
mately 6 seconds when the ignition switch
is turned to the "ON" position.
The following components are monitored
by the indicator:
Front sub sensor (Right-hand side)
Front sub sensor (Left-hand side)
Airbag control module (including impact
sensors)
Seatbelt pretensioner (Driver's side)
Seatbelt pretensioner
side)
Lap belt pretensioner (Driver's side –
Australia models only)
Side airbag sensor (Center pillar right-
hand side – if equipped)
Side airbag sensor (Center pillar left-
hand side – if equipped)
Curtain airbag sensor (Rear wheel
house right-hand side – if equipped)
Curtain airbag sensor (Rear wheel
house left-hand side – if equipped)
All related wiring
And all other airbag components
If the warning light exhibits any of
the following conditions, there may
be a malfunction in the seatbelt pre-
tensioners and/or SRS airbag sys-
tem. We recommend that you take
your
SUBARU dealer immediately to have
the system
(Passenger's
checked and properly repaired, the
seatbelt pretensioners and/or SRS
airbags will operate improperly (e.g.
SRS airbags may inflate in a very mi-
nor collision or not inflate in a se-
vere collision), which may increase
the risk of injury.
Flashing or flickering of the warn-
ing light
No illumination of the warning
light when the ignition switch is
first turned to the "ON" position
Continuous illumination of the
warning light
Illumination of the warning light
while driving
vehicle to your nearest
checked. Unless

System servicing

When discarding a seatbelt retrac-
tor assembly or scrapping the en-
tire vehicle damaged by a colli-
sion, we recommend that you
consult your SUBARU dealer.
Tampering with or disconnecting
the system's wiring could result in
accidental activation of the seat-
belt pretensioner and/or SRS air-
bag or could make the system in-
operative, which may result in se-
rious injury. The wiring harnesses
of the seatbelt pretensioner and
SRS airbag systems are covered
with yellow insulation and the
connectors of the system are yel-
low for easy identification. Do not
use electrical test equipment on
any circuit related to the seatbelt
pretensioner and SRS airbag sys-
tems. For required servicing of
the seatbelt pretensioner, we rec-
ommend that you see your near-
est SUBARU dealer.