Champion 64 PRO Series Installation Manual page 10

Installation
TABLE CONNECTIONS
NOTE:
Tables should be installed after the machine is placed in its final location, properly
leveled and its height properly adjusted. The standard load height for the dishwasher
is 34" [864 mm].
When installing the dish tables:
1. The load end table must slope away from the dishwasher to prevent water from
entering the machine. The unload table should slope toward the machine to prevent
water from pooling on the exit table.
2. The dish rack must not hit the end of the table as it enters or exits the machine.
Adjust the table until the track height of the machine is approximately 1/4" above the
table edge.
3. Set the tables inside the machine making sure the table flange fits against the wash
tank wall. Attach the tables to the machine applying a silicone sealant to the mating
surfaces. See Fig. 4.
25" [635]
Machine Width
21-3/4" [552]
Opening
20" [508]
Inside Track
Fig. 2 - Load height.
2
34" [864]
Load Ht.
Up to 10"
8"
1/4"
7-1/2"
21-1/2"
Flange Max
22"
Opening
31"
Overall
Width
Fig. 3 - Suggested table construction.
Wash Tank
Fig. 4 - Attaching the tables.
Flange Detail
1-1/8"
1/4"
1-1/2"
1/8" Min
Curb
Dish table flange
Drill holes,
apply sealant,
fasten to wash tank